AS7580 Blow Dry & Style – Caring 1000W Rotating Airstyler – Värmeborste

Prepare the hair for styling • Wash and condition the hair as normal. • Squeeze out excess moisture with a towel and comb through. • Using the pre-styling nozzle rough dry the length and roots until 80% dry.• Divide the hair into sections, style the lower layers first.To fit/remove attachmentsFit the attachment before you turn on the appliance.CAUTION: Attachments can become hot during use, let them cool before removing. 1 To remove, twist the attachment until the markings line up as shown in figure A and pull it off the power handle. 2 To fit an attachment, align the symbols on the power handle and attachment as shown in figure B then twist the attachment until it locks into place.Speed and temperature settings 1 Plug your styler in to the mains power supply. 2 Turn your air styler on and select the appropriate setting for your hair by sliding the speed/heat selector switch.3 Your air styler has three settings: High heat/speed (O): Thick and difficult to style hair. • Low heat/speed (N): Thin/fine, damaged or bleached hair.• Cool (f): Helps to set your style with cool air. Rotation settings• Only the 40 mm brush rotates.• To use the rotating function press the right arrow (+) on the rotation switch to rotate the attachments clockwise and the left arrow (-) to rotate the attachments anti clockwise.• NOTE: The brush will only start rotating when a temperature setting has been selected. Create volume and shape using the 40mm rotating brush• To dry your roots and add volume, place the brush underneath the section close to the roots and hold for a few seconds, lifting the hair as you dry. • Move the styler downwards through the hair section, at the same time rotate the brush away from the head by pressing and holding -or + as required.• Keep moving the styler downwards to resist the brush rotation. Doing this will create tension through the section of hair.• If the brush spins too quickly release the rotation switch and remove the brush from your hair.• To create shape, continue rotating the brush until you reach the ends of the hair and then roll the ends under.• For even more volume, wrap the bottom of the hair section around the brush. Press and hold the applicable rotation switch (- +) and wind the entire length of the section around the barrel, stopping at the roots. Release the rotation switch and hold the brush in the hair for a few seconds or until the section is dry.• Repeat this around the head.• Let the hair cool before styling.• Place the protective cover over the brush head to protect the bristles from damage in storage. Create smooth, sleek hair using the firm paddle brush• Starting at the roots, slowly brush through each section just as you would with a normal brush.• To add additional volume tip your head upside down and brush the underneath of your hair.• When dry use your fingers to shape the hair and ends.